Owatrol Oleofloor Classic 1L
Owatrol Oleofloor Classic 1L
36.89€

Owatrol Oleofloor Classic 1L

   0 reviews
Product Code:
Availability:
OW279
In Stock
36.89€
Ex Tax: 29.99€

Owatrol Oleofloor Classic 1L

Owatrol Oleofloor Classic is a water-based oil, enriched with vegetable oil and combined with polyurethane resins to give a hardwearing, wet-look finish. Enhancing the natural beauty of the wood Oleofloor Classic with its wet-look finish gives a deep, rich, warm feel to any wooden floor while it’s excellent penetrating qualities means Oleofloor Classic nourishes the wood and gives long-lasting protection.

Having superior chemical and water resistance Oleofloor Classic is the perfect solution for kitchens and bathrooms while being ideal for staircases, lounges and other similar rooms, where a natural finish is desired.

Ideal uses for Oleofloor Classic

  • Protects and enhances all interior woodwork (floors, stairs, paneling, etc).
  • Quick-drying and easy to apply, Oleofloor Classic is the solution, where the quick turn round of a room is needed.
  • Excellent resistance to abrasion and chemicals, including ammonia-based products.
  • Water repellent.Ideal for use in areas with normal and heavy traffic.
  • Does not require buffing or heavy and expensive application equipment.

Product features

  • Excellent penetration - nourishes the wood from the inside and enhances the natural beauty
  • Easy to apply and quick-drying with a pleasant odour
  • Non-greasy and non-slip
  • Perfect for heavy traffic areas
  • Does not require buffing or heavy and expensive application equipment
Surface preparation

General Directions:

Surfaces must be dry, clean, free of dirt, grease and other surface contamination including previous coatings.

Oleofloor Classic can only be applied to bare wood surfaces or a wood surface that was previously finished with Oleofloor Classic. ALL other finishes MUST be completely and thoroughly removed.

Always clean meticulously with a vacuum cleaner after each sanding, including any dust traps (skirting, radiators, pipes, window sills, etc).

Sand floor back to bare wood using the appropriate system and abrasive grades, depending on the condition of surface and wood species.

Cracks of 2 mm wide or less should be filled with Lianfloor and sanding resumed with 80 or 100 grit paper depending on the last grit used.

Finish with finishing grade up to grit No. 120 or 150 depending on the wood species and thickness of wear layer.

Application
  • Apply 1 or 2 coats of Oleofloor Natural depending on the type of wood and foot traffic.
  • Facing the light and starting opposite the door so as to work towards it, apply a first even and a generous coat of Oleofloor Natural
  • Start at the edge then do the entire surface, working in areas of 2 meters by 2 meters.
  • Allow to dry for 4 hours depending on the ambient conditions.
  • Apply 2nd coat if required.
  • Do not leave more than 12 hours between application of the 1st and 2nd coat.
  • Always maintain a wet edge to avoid overlaps.


DATA SHEET

Reviews (0)

   0 reviews
Write a review
Related Products